gEDA-user: footprint too large

[Patrick Dupre <pd520@xxxxxxxxxx>]

Hello,

I have components (typically a RCY200) whose footprint is larger than
the physics shape and I would like in pcb to move it a bit out of the
print board, ie the connections of course will stay on the print board
bu the footprint (the round shape) could go a bit off.
How can I do it ?

thank.

--
---
==========================================================================
 Patrick DUPRÉ                      |   |
 Department of Chemistry            |   |    Phone: (44)-(0)-1904-434384
 The University of York             |   |    Fax:   (44)-(0)-1904-432516
 Heslington                         |   |
 York YO10 5DD  United Kingdom      |   |    email: pd520@xxxxxxxxxx
==========================================================================


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user