Re: gEDA-user: Drill guide

[Stefan Salewski <mail@xxxxxxxxxxxx>]

Am Mittwoch, den 05.11.2008, 19:44 +0000 schrieb ST de Feber:
> OK. Found it.
> What i get is a smaller pad in a pad.
> I this the way it should be ?
> 
> grtz
> 
> Simon
> 

If you mean "a smaller HOLE in a pad" -- yes, I think this is how its
works. If there is (only) a small area in the center of pins/pads not
plated with copper, then the drill should center itself. (I have never
used this, because I do not make pcb boards at home since many years)




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user