Re: gEDA-user: Want to Use TI's symbols, footprints

[Ethan Swint <eswint.ramu@xxxxxxxxxxx>]

I'll give it a whirl!

Thanks,
Ethan

Steve Meier wrote:
> A demonstration of why one should do a minimal test before sending out
> code.
>
> Looks like the previous email had a version where I am working on nets.
>
> For those who care try this version:
>
>
> On Thu, 2008-11-13 at 09:20 -0800, Steve Meier wrote:
>   
>> I have done a fair amount of work on translating entire PADs ASCII file
>> format projects into PCB file format.
>>
>> This includes translating the embedded foot prints.
>>
>> The attached python script does a translation minus three points
>> ( thermals, netlist, pin numbers are numerically listed and not the
>> alpha numeric that devices such as BGAs use)
>>
>> Also, it generates multiple overlapping vias that PCB complains about
>> and then eliminates all but one.
>>
>> You might try to use it to translate the TI foot prints. Or if you like
>> modify it to translate the TI foot prints.
>>
>> Steve Meier
>>
>> _______________________________________________
>> geda-user mailing list
>> geda-user@xxxxxxxxxxxxxx
>> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>>     
>> ------------------------------------------------------------------------
>>
>>
>>
>> _______________________________________________
>> geda-user mailing list
>> geda-user@xxxxxxxxxxxxxx
>> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user