gEDA-user: Just another minor pcb bug

[Stefan Salewski <mail@xxxxxxxxxxxx>]

pcb 20080202 (GTK)

If Auto enforce DRC clearance is on, lines (traces) starting from a pad
always snap to one of the pad endpoints. It is impossible to start the
line from an arbitrary grid point over the pad.

I think this will be a known bug to developers. If not: At

http://www.ssalewski.de/tmp/

a board fragment called b1.pcb is available.
In left upper corner there is a device called SSP100 with large pads.
Try to start a line (with line tool) from one of the grid points over
this pad.
It will always snap to pad endpoints.

Best regards

Stefan Salewski




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user