Re: gEDA-user: Just another minor pcb bug

[Stefan Salewski <mail@xxxxxxxxxxxx>]

Am Samstag, den 22.11.2008, 23:22 +0000 schrieb Peter Clifton:
> On Sat, 2008-11-22 at 21:52 +0100, Stefan Salewski wrote:
> > pcb 20080202 (GTK)
> > 
> > If Auto enforce DRC clearance is on, lines (traces) starting from a pad
> > always snap to one of the pad endpoints. It is impossible to start the
> > line from an arbitrary grid point over the pad.
> 
> Even if you hold down the shift key when starting the trace?
> 

SHIFT makes no difference for this bug -- "Crosshair snaps to pins and
pads" is off, "Auto enforce DRC clearance" is on. Snaps to pad
endpoints. If I switch "Auto enforce DRC clearance" off snap to grid
points works fine as desired.





_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user