Re: gEDA-user: Just another minor pcb bug

[Ben Jackson <ben@xxxxxxx>]

On Sun, Nov 23, 2008 at 12:33:33AM +0100, Stefan Salewski wrote:
> 
> SHIFT makes no difference for this bug -- "Crosshair snaps to pins and
> pads" is off, "Auto enforce DRC clearance" is on. Snaps to pad
> endpoints. If I switch "Auto enforce DRC clearance" off snap to grid
> points works fine as desired.

I haven't tried your board, but try turning on the visible DRC clearance.
It may be that you're not getting snapping, just a fine pin pitch plus
large clearance only leaves a narrow gap where the line can go.

-- 
Ben Jackson AD7GD
<ben@xxxxxxx>
http://www.ben.com/


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user