Re: gEDA-user: PCB: AutoRouter

[Ineiev <ineiev@xxxxxxxxx>]

On 11/27/09, Stefan Salewski <mail@xxxxxxxxxxxx> wrote:
> All my knowledge is from this list: toporouter works more or less fine
> with boards with no existing traces. So I used tut1.pcb, deleted all
> existing traces and polygons (all in top and bottom layer), pressed key
> "O" to optimize rats nest and :toporouter(). Toporouter uses the active
> layers for traces, so I deactivate layers called "unused" before.

That was my mistake. I tried to route partially routed board. thanks!

> I can see no PNG files, not in my working directory, not in /tmp or
> similar places.

Just checked the sources; looks like all places where that output might occur
are commented out.

> And yes, PNG output is enabled and works.

Actually, the features are not related.

Regards,
Ineiev


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user