Re: gEDA-user: Re: Design changs required to mill PCBs?

[Bob Paddock <bob.paddock@xxxxxxxxx>]

On Tuesday 03 October 2006 19:05, DJ Delorie wrote:

> No fair, now I'm jealous.  I want expensive toys too!  ;-)

One of the companies I do consulting for
bought that machine.  I think their long term plan
is to do prototype boards for people in the Pittsburgh area.
Right now they are just doing in house boards.

I always wanted one myself.  How that I've actually used it,
I think the funds could have been better used on test
equipment.   It makes $33, http://www.33each.com , 
for a single two layer board look
cheap when you consider all of the time you have to put
into getting the boards produced.  Just wish someone
would come out with equivalent multilayer pricing.


-- 
 http://www.softwaresafety.net/ http://www.designer-iii.com/
                 http://www.unusualresearch.com/


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user