Re: gEDA-user: home-made 4 layer board idea

[gene glick <carzrgr8@xxxxxxxxxxxxx>]

how about layer registration?  If the tolerances are out of whack, 
nothing will line up very well.

DJ Delorie wrote:
> > Don't forget the chemicals, tanks, protective gloves, resist,
> > photomask (or equivalent).
>
> I'm all set on that.  I did the two prototypes for the smd challenge
> myself, for example, that's 6 mil rules.
>
> But I haven't seen any 0.016 single clad in small quantities yet.  Not
> that I've been looking much.
>
>
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user