Re: gEDA-user: Howto make solder mask extend equal for all pads in layout?

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Sat, 2008-10-04 at 10:22 -0400, DJ Delorie wrote:
> > Is there something similar for copper clearing of pads/pins in polygons?
> 
> Not that I'm aware of.  Again, you could write one pretty easily by
> copying the existing one.

changeclearsize(selected,10,mil)

Also works for mask, if you select the mask layer before running it.


Ah crud... just realised I've got a cat-hair re-assembled into my LCD
panel. (Aside from the couple of hot-columns and failed left hand half.

Not having a good laptop week.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user