Re: gEDA-user: More eye-candy

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Sat, 2009-10-17 at 07:30 -0400, gene glick wrote:
> > Alternatively, if you don't want the 3D stuff, just the GL rendering,
> > the "before_pours" branch should be good.
> > 
> > git clone git://repo.or.cz/geda-pcb/pcjc2.git
> > cd pcjc2
> > git checkout -b before_pours origin/before_pours
> > autogen.sh
> > ./configure --enable-dbus --enable-gl
> > make
> > make install
> > 
> > 
> 
> This build has the 3d stuff too - unless I did it wrong :)

Hmm, yes.. technically.. although it doesn't draw any z-coordinates, so
if you adjust the trackball - you will always see the same flat board
(at an angle).



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user