Re: gEDA-user: Working on xgsch2pcb-0.1.3 for Gentoo

[Stefan Salewski <mail@xxxxxxxxxxxx>]

On Wed, 2009-10-28 at 00:33 +0100, Stefan Salewski wrote:
> On Wed, 2009-10-28 at 00:25 +0100, Stefan Salewski wrote:
> 
> > 
> > Oh -- updating the (non existent) pcb board is not sucessfull
> 
> 
> Indeed I got the impression of a near chrash, so I send my last post
> fast...
> 
> Redraw of GTK/Gnome windows was blocked.
> But now its fine again.
> All elements were put in the upper left corner of the new board, and rat
> lines are drawn, and I got very many, many, many
> 
> Warning! Net "unnamed_net385" is shorted to net "unnamed_net270"
> Warning! Net "unnamed_net385" is shorted to net "unnamed_net264"
> Warning! Net "unnamed_net385" is shorted to net "unnamed_net261"
> Warning! Net "unnamed_net385" is shorted to net "unnamed_net284"
> 
> Sure, the pins overlap.
> 
> 

I think automatically doing the "O" (optimize rat lines) action in PCB
when a new board with all elements overlapping in the upper left corner
was created is not a good idea.

My first test with the existent unmodified board gave no problems, but
of course new users will start with unpopulated boards.

I will do some more tests tomorrow.
(This was for AMD64, gcc 4.4.2, kernel 2.6.31)

Best regards

Stefan Salewski




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user