Re: gEDA-user: moving treces

[Ethan Swint <eswint.ramu@xxxxxxxxxxx>]

Vincent Onelli wrote:
> The task was a time consuming one, the most difficult was moving the trace because the trace brakes at every bend.
>   
Select a train of traces, then save while they are selected.  Use a text 
editor to increase the line width of the lines containing the "selected" 
attribute.
>         Is there away to retain connection while moving? 
>   
Turn on "Rubber-band" mode under the Settings menu.
>         Vinny
>
>
>
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>
>   
begin:vcard
fn:Ethan Swint
n:Swint;Ethan
org:Ramu Inc
adr;dom:Suite 2220;;3154 State Street;Blacksburg;VA;24060
email;internet:eswint.ramu@xxxxxxxxxxx
title:Senior Engineer
tel;work:540.443.3100
tel;cell:516.521.1313
version:2.1
end:vcard


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user