Re: gEDA-user: Segmentation Fault

[Dan McMahill <dan@mcmahill.net>]

On Tue, Sep 07, 2004 at 01:42:38PM -0700, John Luciani wrote:
> 
> I have found a condition that causes PCB to 
> Segment fault.
> 
> I created an element that has a mounting hole 
> but I forgot to change bit 3 in the pin flag. The 
> PCB layout below contains the element with the
> incorrect pin flag. The netlist below just 
> connects all three pins of the symbol.
> 
> The following actions produce the segment fault:
> 
>  1. Load the PCB layout.
>  2. Load the netlist
>  3. Optimize the ratsnest.
> 
> (* jcl *)
> 
>    Pin(-275 0 96 79 "" "1" 0x01)
>    Pin(0 0 96 79 "" "2" 0x01)
>    Pin(275 0 96 79 "" "3" 0x01)
>    Pin(-777 -287 96 79 "" "" 0x01)
>    Pin(777 -287 96 79 "" "" 0x01)

Its because there is no pin number for the last 2 pins.  I'll see about
fixing pcb to avoid a segfault, but you should fix the element.

-Dan

--