[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: Request for comments

To: geda-user@xxxxxxxxxxxxxx
Subject: Re: gEDA-user: Request for comments
From: DJ Delorie <dj@xxxxxxxxxxx>
Date: Fri, 7 Sep 2007 23:21:50 -0400
Delivered-to: archiver@xxxxxxxx
Delivered-to: geda-user@xxxxxxxxxxxxxx
Delivery-date: Fri, 07 Sep 2007 23:22:01 -0400
In-reply-to: <20070908031239.GA55582@xxxxxxxxxxxxxxxxxxx> (message from Ben Jackson on Fri, 7 Sep 2007 20:12:40 -0700)
List-archive: <http://www.seul.org/pipermail/geda-user>
List-help: <mailto:geda-user-request@moria.seul.org?subject=help>
List-id: gEDA user mailing list <geda-user.moria.seul.org>
List-post: <mailto:geda-user@moria.seul.org>
List-subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=subscribe>
List-unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=unsubscribe>
References: <46E2032A.2050406@xxxxxxxxxxxxxxx> <20070908031239.GA55582@xxxxxxxxxxxxxxxxxxx>
Reply-to: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Sender: geda-user-bounces@xxxxxxxxxxxxxx

> Your soldermask clearance is about 1.5mil.  That's smaller than the
> printing tolerances of most fabs.

Hmm, it's exactly the tolerance of the fabs I use.  But pcb also has a
"MinMaskGap()" action specifically designed to grow masks to meet fab
tolerances :-)


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

References:
- gEDA-user: Request for comments
  - From: andrewm
- Re: gEDA-user: Request for comments
  - From: Ben Jackson

Prev by Author: Re: gEDA-user: Request for comments
Next by Author: Re: gEDA-user: PCB problems
Previous by thread: Re: gEDA-user: Request for comments
Next by thread: Re: gEDA-user: Request for comments
Index(es):
- Author
- Thread