Re: gEDA-user: avoid route on component layer for specific component

[John Griessen <john@xxxxxxxxxxxxxx>]

Ben Jackson wrote:
 In pcb you could probably get close
> to the same effect by drawing walls around the pins in the copper which
> you delete later.

Yes, this is easy using groups and changing the group shown when
autorouting vs. doing hand layout.    When we get scripting to be easier,
it will be a snap to sequence steps like this and you could then prefer to
always show your keepout layer for that side, then autoroute, then un-show it...

John Griessen
Austin TX



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user