Re: gEDA-user: rat width

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Thu, 2009-04-02 at 18:59 -0400, DJ Delorie wrote:
> > I am working on a design with a lot of small parts and pcb's default
> > rat width is too wide to see what I'm doing.  I don't see a setting
> > for this.  Where should I look?
> 
> Add this to $HOME/.pcb/settings :
> 
> rat-thickness = 3
> 
> That forces it to be 3 pixels instead of a fixed size.  Values 0..19
> are pixels; anything larger is PCB units (i.e. 100 means "1 mil").

Yuck, nastiness!

That is just the kind of magic which will end up confusing people in
years to come.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user