Re: gEDA-user: This patch is breaking compile

[kqt4at5v@xxxxxxxxxxx]

On Fri, 19 Aug 2011, Markus Hitter wrote:

> Am 15.08.2011 um 22:37 schrieb kqt4at5v@xxxxxxxxxxx:
>
> > I was especially interested in the drillmill function but I have not been 
> > able to get that to work
> > I check the box and only get plain drilling
>
> Did you look into the "outline" G-code file? As drill-milling and outline 
> milling often uses the same tool, I've put the drill-mills there.

As a beginner this was not very intuitive
I wanted to drill mill but not cut out the outline so I ignored the outline setting
If I adjust the outline settings properly I get drill milling but also outline cutout

Thanks
Richard


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user