Re: gEDA-user: Pads do not clear polygons

[Ben Jackson <ben@xxxxxxx>]

On Wed, Dec 05, 2007 at 09:21:31PM -0600, Martin Maney wrote:
> 
> (1) would the pin still be checked for minimum annular ring size, where
> it could fail DRC because it's been reduced to avoid this problem with
> the overlaid pads even though the copper is actually still full width? 
> I expect so.

Yes, however you can make it bigger as well, and it only needs to be
by .01mil, I suspect.  0.1mil would be more than enough, and probably
indistinguishable in a final board.

-- 
Ben Jackson AD7GD
<ben@xxxxxxx>
http://www.ben.com/


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user