Re: gEDA-user: Pads do not clear polygons

[Harry Eaton <haceaton@xxxxxxxxx>]

--- Martin Maney <maney@xxxxxxxxx> wrote:

>... I used it with the pin
> slightly reduced (1),
> and the clearances work fine, but on the wrong
> sides...

Actually this is simply that you have the layer named
"component" on the solder side and the layer named
"solder" on the component side. That's a really bad
way
to set up the layer groups.

h.



      ____________________________________________________________________________________
Never miss a thing.  Make Yahoo your home page. 
http://www.yahoo.com/r/hs


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user