Re: gEDA-user: Pads do not clear polygons

[Martin Maney <maney@xxxxxxxxx>]

On Sat, Dec 08, 2007 at 10:12:45AM -0800, Harry Eaton wrote:
> Actually this is simply that you have the layer named
> "component" on the solder side and the layer named
> "solder" on the component side. That's a really bad
> way
> to set up the layer groups.

Yes, that seems logical.  As best I recall *I* didn't do any setup of
the layers - that was how PCB had them by default.  So of course I
never thought to check that.

That's interesting - it's in ~/.pcb/preferences, and it does seem to
be different than what it sets up de novo, but I have no memory of
intentionally changing groups, either through the GUI or by editing
preferences (well, until I edited it just now to put it back to sane).
Speaking of the layers/groups GUI, I stumbled across that once upon a
time, but now I can't find it.  Hints?

Thanks!

-- 
[the combination of iPod and iTunes is like]
buying a 21st-century device
to live in the seventies.  -- Wes Phillips



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user