Re: gEDA-user: Some (newbie?) problems GSpiceUI, PCB

[DJ Delorie <dj@xxxxxxxxxxx>]

> 2. PCB's print command seems quite buggy in PS/EPS format; George M.
> Gallant, Jr. has already reported some of the the problems on this
> mailing list, but so far without a reply or a remedy:

Could you try the printing module in the HID version of pcb?
http://www.delorie.com/pcb/

At least we'd know if the problems sill persist.

> The EPS format has its own problems, but I'm not sure PCB is at
> fault here: when printed, no paper margins are taken into account,

EPS is not for printing, it's for embedding in other documents.
Hence, no margins.