[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: PCB: Is the insert-point function working?

To: geda-user@xxxxxxxx
Subject: Re: gEDA-user: PCB: Is the insert-point function working?
From: DJ Delorie <dj@xxxxxxxxxxx>
Date: Sun, 15 Jan 2006 20:44:26 -0500
Delivered-to: archiver@seul.org
Delivered-to: geda-user-outgoing@seul.org
Delivered-to: geda-user@seul.org
Delivery-date: Sun, 15 Jan 2006 20:44:41 -0500
In-reply-to: <43CAF864.30505@comcast.net> (message from Harry Eaton on Sun, 15 Jan 2006 20:35:32 -0500)
References: <17702B6B8A6ED241BF737ACF8D432DA009A7FF@aplesjustice.dom1.jhuapl.edu> <200601142307.k0EN7Fkl021838@envy.delorie.com> <43CA2F19.50202@comcast.net> <it5bit.bgy9s0@webmail1.hrnoc.net> <200601151811.k0FIBbv6006469@envy.delorie.com> <43CAF864.30505@comcast.net>
Reply-to: geda-user@xxxxxxxx
Sender: owner-geda-user@xxxxxxxx

> You don't have to click inside the poly, you can click "near" (within 
> SLOP) to the edge in question,

I thought "slop" was just compensating for the fact that a pixel
covers a non-zero area of the board?  Is slop bigger than a pixel?

Follow-Ups:
- Re: gEDA-user: PCB: Is the insert-point function working?
  - From: Harry Eaton

References:
- gEDA-user: PCB: Is the insert-point function working?
  - From: Jose, Marshall
- Re: gEDA-user: PCB: Is the insert-point function working?
  - From: DJ Delorie
- Re: gEDA-user: PCB: Is the insert-point function working?
  - From: Harry Eaton
- Re: gEDA-user: PCB: Is the insert-point function working?
  - From: Phil Taylor
- Re: gEDA-user: PCB: Is the insert-point function working?
  - From: DJ Delorie
- Re: gEDA-user: PCB: Is the insert-point function working?
  - From: Harry Eaton

Prev by Author: Re: gEDA-user: PCB HID project
Next by Author: Re: gEDA-user: PCB: Is the insert-point function working?
Previous by thread: Re: gEDA-user: PCB: Is the insert-point function working?
Next by thread: Re: gEDA-user: PCB: Is the insert-point function working?
Index(es):
- Author
- Thread