Re: gEDA-user: PCB multiple footprint selection

["Ed & Angie S." <edangies@xxxxxxxxx>]

Perfect.  Thank you John and Phil.  In spite of being pretty far along with 
component placement, I hadn't noticed and tried that button yet.

Ed

----- Original Message ----- 
From: "John Luciani" <jluciani@xxxxxxxxx>
To: "gEDA user mailing list" <geda-user@xxxxxxxxxxxxxx>
Sent: Monday, January 29, 2007 3:24 PM
Subject: Re: gEDA-user: PCB multiple footprint selection


> On 1/29/07, Ed & Angie S. <edangies@xxxxxxxxx> wrote:
>
> > At first,I was expecting the selection to only take components on the 
> > active
> > layer.  Then I thought turning off the opposite layer would disable the
> > component selection on the opposite side of the board but that didn't 
> > work
> > either.  I checked the release notes for newer versions of the software 
> > and
> > didn't see that this issue had been covered but, I was still wondering if 
> > a
> > newer version might have improved this behavior or if someone had a
> > suggestion for working around it more effectively.
>
> In my PCB version there is a button labeled "far side". Clicking "far
> side" makes
> the components on the opposite side of the board invisible and 
> unselectable.
>
> (* jcl *)
>
>
> --
> http://www.luciani.org
>
>
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user