Re: gEDA-user: Metric units [Was: Re: Open GL survey (for PCB)]

[Stefan Salewski <mail@xxxxxxxxxxxx>]

Am Mittwoch, den 28.01.2009, 20:36 +0000 schrieb Peter Clifton:
> 
> Didn't we come to the view at some point, that using a sufficiently
> small metric unit internally would work fine?
> 
> (Due to the definition of 1" = 2.54cm allowing us to precisely specify
> both metric and imperial units, given a sufficiently small metric unit?)
> 
> 

I reported about some problems with mm grid, so I hope I remember the
discussion correctly:

I think result was that 1nm (nanometre) base-unit should work perfectly.
(in my opinion larger units may work good, if rounding is smart.)
 



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user