Re: gEDA-user: Assign polygon/rectangle to a net in PCB

["James Johnston" <mail@xxxxxxxxxxxx>]

Doh... problem solved... figured it out...  My minimum touching copper
overlap was 10 mils when I was running 8 mil traces.  That's a new DRC
setting I'm not used to, but good to know it's there.

-----Original Message-----
From: geda-user-bounces@xxxxxxxxxxxxxx
[mailto:geda-user-bounces@xxxxxxxxxxxxxx] On Behalf Of DJ Delorie
Sent: Tuesday, June 17, 2008 13:24
To: geda-user@xxxxxxxxxxxxxx
Subject: Re: gEDA-user: Assign polygon/rectangle to a net in PCB


Try shutting off pins and seeing if there are tiny traces under the
pins or pads that might be causing this.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user