Re: gEDA-user: gschem, zooming

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2008-06-18 at 15:30 +0200, Stefan Salewski wrote:
> When I do "ve" (view extend) in gschem, only about 90% of the window is
> popolated. This may be fine -- the still empty room can be used to
> insert new symbols. But in most cases I would prefer that "ve" fills the
> whole window contents, so that sheet rectangle in near the window
> borders. Is there a configuration?

gschem/src/a_zoom.c, line 181:

  relativ_zoom_factor = (zx < zy ? zx : zy) * 0.9


(So no, no config, but its easy to munge. I also munged my copy to zoom
in smaller increments with the mouse wheel).

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user