Re: gEDA-user: egg on face removed... but why...?

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Thu, 2008-06-19 at 13:33 -0700, Ben Jackson wrote:
> On Thu, Jun 19, 2008 at 04:25:14PM -0400, DJ Delorie wrote:
> > 
> > Leave PCB running.  Run gsch2pcb (it shouldn't change the .pcb file,
> > since you didn't remove/rename any elements).  In PCB, load the new
> > netlist and type "o".
> 
> The important point is that the netlist is generated separately from the
> PCB but you must merge them in PCB any time you regenerate it.


<plug>

xgsch2pcb handles this all for you, and can also update new components
into a running copy of PCB. (It drops them in a pile in the top corner).

</plug>

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user