Re: gEDA-user: Surface mount footprint pin pitch changes at different magnifications in PCB

[DJ Delorie <dj@xxxxxxxxxxx>]

As a general rule, always check the part against a printout if you're
unsure of the footprint.  However, the "right footprint" issue is
different than the "looks right" issue.  Use the Mark (ctrl-m) to
measure the distance between various pins and compare to the chip's
specs to see what's up.

Did you etch this board yourself, or have it professionally made?


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user