gEDA-user: "Open Pinout Menu" issue?

[Vanessa Dannenberg <vanessadannenberg@xxxxxxxxx>]

Am I the only one who is having trouble displaying the Pinout Window?

Particularly, on that PowerSID project...  I'm writing the documentation to go 
with it, and I needed to double-check the pinout of one of the parts to make 
sure I did everything right..

When I try to get the pinout, I either get a blank footprint (no pin names at 
all), or all the pins are smashed over to the left, or the pins' names are 
shifted up by one or more pins, or a combination of these.  Usually, pin 1 is 
not displayed at all (I'm guessing this has to do with it having the square 
flag set).

Can someone load the PowerSID project and see if you can verify this problem?  
The 74F520 near the top-left is one part that displays this problem.

I just did a CVS update and recompile of PCB a few minutes ago just to make 
sure this hasn't already been seen and fixed..

If I just start a new project and place any random component on screen, I can 
open the pinout window just fine then.

Getting a little sleepy now, please disregard any typos or poor 
grammar... :-) )

-- 
"Sometimes paranoia can be helpful. Usually it
isn't, and when you learn that, life improves."
Vanessa Dannenberg