Re: gEDA-user: pcb doesn't find my pins

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2010-03-03 at 08:55 -0500, Jim wrote:

> So I thought maybe the Element line wasn't right since it looks 
> different from yours, so I changed it to
> 
> Element("" "Wiz812mj.fp" "U102" "unknown" 10 10 3 100 0 100  "")

> And now it fails on line 74. 
> 
> I'm getting more confused by the minute.

There are various different syntaxes which have been in use over the
years, and PCB ought to be able to read them all. It might be that some
have got broken.

I'm out of the depth at which I can just reply "off the top of my head",
so I'm afraid this will have to wait until someone can look into it in
more detail.

For now, just don't run the .cmd file which is screwing things up.

PS.. what PCB version do you have.
What gEDA version do you have.

(Both are relevant to the design flow).

Best wishes,

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user