Re: gEDA-user: postscript file fontsize

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Tue, 2010-03-09 at 16:16 +0100, Stefan Salewski wrote:
> On Tue, 2010-03-09 at 16:01 +0100, Piter_ wrote:
> > Hi all.
> > How can I increase fontsize in gschem? If I make a ps file from
> > schematics I have to zoom on part of it to be able to read values of
> > components.
> > Thanks
> > Petro.
> > 
> 
> OK, Peter Clifton already answered your question...
> 
> But for me your problem remains strange. The symbols shipped with gEDA
> have a font size which have a nice relation to the graphics.
> 
> And you complain only about postscript output, not about screen output
> inside of gschem.
> 
> So I would assume there is something wrong. For gEDA prior to 1.6 there
> was a scaling factor for postscript font output. May that be your
> problem?

Good point.. if things seem significantly incorrect in the postscript
output, please send a small example (.ps output and source schematic),
for us to check.

Things should appear pretty much in proportion on screen and in the
postscript output.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)
Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user