[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: Clearing mask to mount shields

To: geda-user@xxxxxxxx
Subject: Re: gEDA-user: Clearing mask to mount shields
From: "Phil Taylor" <phil@xxxxxxxxxxxxxxxxxxxxxxxx>
Date: Fri, 5 May 2006 23:45:43 -0400
Delivered-to: archiver@seul.org
Delivered-to: geda-user-outgoing@seul.org
Delivered-to: geda-user@seul.org
Delivery-date: Fri, 05 May 2006 23:46:10 -0400
In-reply-to: <20060506014636.GA9291@dlharmon.com>
References: <20060505155838.GA8372@dlharmon.com> <445B7A78.9080802@mcmahill.net> <20060505190642.GB8372@dlharmon.com> <a06230949c08154d7efe9@[130.161.115.44]> <20060506014636.GA9291@dlharmon.com>
Reply-to: geda-user@xxxxxxxx
Sender: owner-geda-user@xxxxxxxx

Darrell Harmon <dlharmon@xxxxxxxxxxxx> wrote:

> I went with 1 via every mm. So far, I have 2110 vias, so I should be able
> to stay under 2500 by the time I finish routing it.

Can you plate the edges and save drilling 2k holes?  (assuming the holes are
on the perimeter of your board).

phil

Follow-Ups:
- Re: gEDA-user: Clearing mask to mount shields
  - From: Darrell Harmon

References:
- gEDA-user: Clearing mask to mount shields
  - From: Darrell Harmon
- Re: gEDA-user: Clearing mask to mount shields
  - From: Dan McMahill
- Re: gEDA-user: Clearing mask to mount shields
  - From: Darrell Harmon
- Re: gEDA-user: Clearing mask to mount shields
  - From: J.D. Bakker
- Re: gEDA-user: Clearing mask to mount shields
  - From: Darrell Harmon

Prev by Author: Re: gEDA-user: Hfe Gain
Next by Author: Re: gEDA-user: reflow oven
Previous by thread: Re: gEDA-user: Spectrum analyzer: was Clearing mask to mount shields
Next by thread: Re: gEDA-user: Clearing mask to mount shields
Index(es):
- Author
- Thread