Re: gEDA-user: gschem won't connect nets

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Mon, 2008-05-26 at 14:58 +0000, Kai-Martin Knaak wrote:
> On Sat, 24 May 2008 21:46:26 -0500, Paul Probert wrote:
> 
> > The only time I remember turning off the snap lately was when I was
> > modifying a symbol. Hmm, I see that it stays off when I go Hu after
> > working on a symbol.
> 
> This is clearly a wart. I have been hit by this kind of grid property 
> persistence, too. At minimum there should be a big, fat warning, if the 
> grid is anything other than 100 when the current schematic changes. 

We could perhaps make the grid size a property of the current schematic,
rather than the current gschem window.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user