Re: gEDA-user: gschem won't connect nets

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Sat, 2008-05-24 at 22:25 -0400, Rick Collins wrote:

> Is there a reason that this can't be fixed in this software, either 
> by making it impossible to place pins off grid or by having the 
> software capable of making connections to pins that are off grid?  Or 
> perhaps the software should check this and give a warning when 
> placing a part so that it is not connectable.  Or a final suggestion, 
> a means of easily correcting all parts that are off grid...

Magnetic nets mode might be the way to allow this.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user