Re: gEDA-user: Out and In symbols in gschem & getting net names to come out in PCB

[Russell Dill <russd@xxxxxxx>]

On Sun, May 1, 2011 at 3:49 PM, Rob Butts <r.butts2@xxxxxxxxx> wrote:
> Â I'm using out and in symbols in gschem to label nets in a schematic and
> Â tie nets together without traces running everywhere. ÂI set the net
> Â attribute of the corresponding out and in symbols in the schematic to
> Â the same value (clk for example) and connect these symbols to various
> Â pins of various chips. ÂWhen I run gsch2pcb and look at the netlist I
> Â don't see those nets listed which makes me feel the pins of all the
> Â chips I tie the out and in symbols to are not connected. ÂHow do I use
> Â these symbols correctly?
> Â Thanks


Just put the attribute on the net and drag the attribute name over to
the in/out symbol


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user