[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: An idea: rework design support



   Would it be useful. Yes
   Would it be easy  No.
   When you cut a trace you might split a node into two nodes. Or then
   again you might not if there is a loop on the PCB. You would need to
   extract connectivity from the layout to be sure. The cut on the PCB is
   unlikely to map to a nice easy spot on the schematic where you could
   make the equivalent cut.  You may wind up having to redraw the
   schematic.
   John Eaton

_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user