Re: gEDA-user: pcb, how to remove mm garbage (very short lines)?

["Duncan Drennan" <duncan.drennan@xxxxxxxxx>]

> After using pcb 20080202 (GTK) for more than hundred hours for the
> current layout know, I think the mm issues are really the most important
> bugs of this program. (If most of the footprints have mm grid, then it
> is nearly impossible to use mil grid.) Fixing these mm rounding issues
> may be difficult and a lot of work -- my guess is that pcb program was
> designed for mil grid, and mm units are added later as a "fix". So
> complete redesign of position storage and calculation may be needed.

Stefan, I haven't really had problems using the mm grid, but maybe I
don't understand what your issue is exactly. Is the problem the small
trace that appears underneath a copper pad when you complete a line to
a pad snap point?


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user