Re: gEDA-user: "mm garbage", cannot repro

[Stephan Boettcher <boettcher@xxxxxxxxxxxxxxxxxx>]

Ben Jackson <ben@xxxxxxx> writes:

> 1)  Change the _/ modes to not create those segments if they're not
> electrically necessary.  This is a pretty good fix and you'd only see
> odd behavior if you were in rubberband mode and grabbed the corner to
> move it.  It wouldn't count as "connected" in that case.  If you grabbed
> one of the *lines* it *would* count (due to changes I made last year to
> fix other problems with tiny connector segments that appear when you go
> from grid to pad).
>
> 2)  Change the line removal code to check both endpoints for tiny
> segments and delete them.
>
> And a less quick way:
>
> 3)  Add the requested 'remove net' feature which would presumably be
> more popular than 'remove line' in cases where these tiny segments would
> appear and it would handle this cause automatically.

4) The _/ mode should always end 45deg lines on grid points, even
if they not end up being exactly 45 deg.



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user