Re: gEDA-user: gPCB Polygon Best Practices

[DJ Delorie <dj@xxxxxxxxxxx>]

> I think you made that board on PCB Lesstif version, am I right?

Yup.  Just before the polygon clipper code.

> Around P9, P8, P7 and P6 has a polygon. Here it appeared in dark
> red, first layer (component)

That poly should be on the solder side.  It connects to VCC (see
thermals on P6-9's VCC pin).

> but over that polygon passes a lot of lines from that same board,
> and they are not connected. That polygon makes sense if become blue
> (second layer), and made him blue by changing to the second layer
> and pressed m over the polygon, and all made sense.

My layer groups:

TOP BOT
 x	component
     x	solder
 x	comp-vcc
 x	comp-gnd
     x	solder-vcc
     x	solder-gnd
 x	comp-vcc-poly
 x	comp-gnd-poly
     x	solder-vcc-poly
     x	solder-gnd-poly

Note that there are ten layers.

> I dont know, but I think there are some incompatibility with lesstif
> x gtk .ocb generated files...

Shouldn't be.  The part that saves the file is independent of the GUI.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user