Re: gEDA-user: buzzing board

[DJ Delorie <dj@xxxxxxxxxxx>]

> One good way to address this and other such possibilities would be
> to start de-soldering each component that is not strictly necessary
> to drive the OLED.

It doesn't bother me THAT much ;-)

> If you get down to just the CPU, OLED, and required support
> components, I would go so far as to remove the CPU and its required
> components, and solder on wires to drive the OLED from off-board.

I have two more boards, plus the breadboard still works.  Maybe I'll
just let it go for now, and if it's the same on all three boards I'll
worry about it then.

But I'll try to remember to pick up a piezo thing at RS next time I'm
over there.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user