On 08/22/2011 07:45 AM, Kovacs Levente wrote:
I open up a new schematic, place two instances of 7404-1, edit the attributes of the second one, promote the "slot" attribute, edit the newly-accessible one, change it to "2", save it, save the sheet, exit gschem, restart, and load the sheet.I am guessing that you edit the symbol too. You don't have to. You just have to save the sheet, not the symbol.
Oh nono, I didn't do that...I was tired when I typed that. Where I said "save it, save the sheet" I just meant "save the sheet". I do not edit the symbols alone, other than double-clicking on them and promoting/modifying the slot attribute.
You should promote the slot attribute for both instances.
Even though slot #1 defaults to 1?In any event, I've tried all combinations, and I still get the same behavior. This is with v1.6.2.20110115. This is repeatable here, using symbol 7404-1 from the default installed library.
This seems like a pretty serious issue; can anyone shed a little light on it?
-Dave
--
Dave McGuire
Port Charlotte, FL
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user