Re: gEDA-user: inexpensive 2-layer pcb prototypes in 2 weeks? 3 weeks? 4 weeks?

[Mark Rages <markrages@xxxxxxxxx>]

On Fri, Feb 18, 2011 at 12:58 PM, John Griessen <john@xxxxxxxxxxxxxx> wrote:
> On 02/18/11 12:12, yamazakir2 wrote:
>>
>> If you need mask/silk I'd just stick with 33 each... the quality is
>> excellent and even with a minimum quantity of 4, it's not that big of
>> a investment if you plan on doing a 150 board run.
>
> My board run coming is for an open hardware project with low volume sales
> potential only and little room for error.  What if the prototype run
> does what it's intended and exposes a flaw before production?

Sounds like a good fit for dorkbot:

http://dorkbotpdx.org/wiki/pcb_order

from the comments: 'anything that can be cut out with a 0.1" routing bit'
-- 
Mark Rages, Engineer
Midwest Telecine LLC
markrages@xxxxxxxxxxxxxxxxxxx


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user