[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: Vias with zero clearance in PCB?

To: geda-user@xxxxxxxx
Subject: Re: gEDA-user: Vias with zero clearance in PCB?
From: DJ Delorie <dj@xxxxxxxxxxx>
Date: Tue, 10 Jan 2006 16:35:46 -0500
Delivered-to: archiver@seul.org
Delivered-to: geda-user-outgoing@seul.org
Delivered-to: geda-user@seul.org
Delivery-date: Tue, 10 Jan 2006 16:35:54 -0500
In-reply-to: <43C428FE.9050602@earthlink.net> (message from joeft on Tue, 10 Jan 2006 13:37:02 -0800)
References: <17702B6B8A6ED241BF737ACF8D432DA009A7F8@aplesjustice.dom1.jhuapl.edu> <200601100214.k0A2EZ2J024087@envy.delorie.com> <20060110040601.GA6524@lrd5-64> <43C3FC47.1090907@comcast.net> <43C428FE.9050602@earthlink.net>
Reply-to: geda-user@xxxxxxxx
Sender: owner-geda-user@xxxxxxxx

> Very good suggestions/tips.  One pitfall you might encounter - some 
> board fab houses check the gerber files and occasionally flag an error 
> when you include zero-length lines (which in the gerber output are 
> distinct in that they are "drawn" rather than "flashed" like pads).  If 
> they don't like them and throw them out, you'll be in for a surprise.

Except that PCB knows to flash them :-)

References:
- gEDA-user: Vias with zero clearance in PCB?
  - From: Jose, Marshall
- Re: gEDA-user: Vias with zero clearance in PCB?
  - From: DJ Delorie
- Re: gEDA-user: Vias with zero clearance in PCB?
  - From: Larry Doolittle
- Re: gEDA-user: Vias with zero clearance in PCB?
  - From: Harry Eaton
- Re: gEDA-user: Vias with zero clearance in PCB?
  - From: joeft

Prev by Author: Re: gEDA-user: NFS Share
Next by Author: Re: gEDA-user: Vias with zero clearance in PCB?
Previous by thread: Re: gEDA-user: Vias with zero clearance in PCB?
Next by thread: Re: gEDA-user: Vias with zero clearance in PCB?
Index(es):
- Author
- Thread