Re: gEDA-user: select entire net/apply netname

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Thu, 2008-01-24 at 14:17 -0800, Steve Meier wrote:
> To set a net's name you only need to add the net=this_net_name to one
> segment of a group of connected net segments.

Make that "netname=...." for an attribute attached to a net.

The names are a little confusing. "net=foo:1" is used to attach to a
component instance, and says connect pin with (pinseq or pinnumber?) 1
to net foo.


-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user