On 7/24/07, DJ Delorie <dj@xxxxxxxxxxx> wrote:
> http://www-nw.uni-regensburg.de/~.grr06742.back.physik.uni-regensburg.de/PCB/GPS_BUG.PCB
I reproduced it.
> If I try to draw a copper rectangle on GND-comp it either doesn't
> draw one at all or scrambles it in the lower left corner. Smaller
> areas work fine though. When zooming it sometimes appears again but
> in the printout it's never right. I get the messages :
I've reported this before, but Harry hasn't offered a fix for it.
He's the only one who really knows how the clipper works.
With sufficient zooming/scrolling, you can make pcb segfault too.
I just ran into this same issue when I was displaying a plane layer where a polygon covers most of the board. When there are a lot of perforations in the polygon due to vias and pins I get a segfault after "sufficient" scrolling.
Joe T
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user