Re: gEDA-user: gsch2pcb creating board.pcb syntax errors?

[Ben Jackson <ben@xxxxxxx>]

On Sun, Jun 03, 2007 at 09:58:57PM -0400, Dan McMahill wrote:
> I left out the most important question.  What exactly did you set your 
> footprint= to in your schematic?  It should be SOT89 and *not* SOT89.fp 
> otherwise you will feed garbage to m4.
> 
> gsch2pcb will search for files without the .fp and then automatically 
> search for files with .fp if the former is gone.

You probably already saw my reply to myself where I came to the same
conclusion as you (about the input to m4).  I thought I was *supposed*
to use .fp, so maybe that's where I went wrong.  With --skip-m4, I also
get the right result.

-- 
Ben Jackson AD7GD
<ben@xxxxxxx>
http://www.ben.com/


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user