Re: gEDA-user: Garbage drawn outside of pcb board area

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Thu, 2010-06-10 at 00:16 +0200, Krzysztof KoÅciuszkiewicz wrote:
> On Tue, Jun 08, 2010 at 09:14:12PM +0100, Peter Clifton wrote:
> 
> > > You were right - it seems the driver is at fault... It wasn't always
> > > like that so I'll try to track down what change broke the rendering.
> > 
> > It might not be the driver's fault if I'm doing evil things like making
> > GL calls out of valid context setup. (Which I was).
> 
> You were right, I have to retract the statement about the driver's fault.

Gah - good catch! I'll roll that code change into my patches when I get
chance. It begs the question why the code "appears" to render OK on the
software driver, Intel driver, ......

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)
Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user