Re: gEDA-user: pcb, how to remove mm garbage (very short lines)?

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2008-11-19 at 22:02 +0000, Peter Clifton wrote:
> On Wed, 2008-11-19 at 09:50 -0500, DJ Delorie wrote:
> 
> > The optimizer should never turn a good board into a bad board, that's
> > always a bug.  The logic in the optimizer isn't that simple, though,
> > so fixing said bugs may be tricky.  Sample boards (and/or patches ;)
> > welcome.
> 
> Not sure if this is a bug or feature, but I dislike the way it adds
> short line-segments when a track doesn't end on the pad.
> 
> I've not been able to get a simple test case to reproduce the bug where
> the track changed angle, however you'll see one annoyance here.
> 
> Flip to the back-side (so you can see added tracks), and press "=". Note
> that a new line-segment is added. Is that desirable?

Oh, forgot to mention, something seems to be messing up the undo serial
numbers during that operation as well.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user