Re: gEDA-user: How to connect pads to anything?

[Stefan Salewski <mail@xxxxxxxxxxxx>]

On Sun, 2010-10-17 at 17:20 +0200, Stefan Salewski wrote:

> My initial guess: Your traces are not in the top and bottom groups, so

Use the layers dialog, and make it similar as tut1.pcb for two layer
layout.

solder           x
GND-solder       x
VCC-solder       x
comonent       x
GND-component  x
Vcc-component  x
unused
unused
(bottom)         x
(top)          x

I set up layers stack when I start a new layout, but I think it will
work if you change it now.




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user